How to make a RC helicopter

The most important step when you fly an RC helicopter is the installation. If your helicopter is not configured correctly bird tip side by side, forward or back, or tail could spiral out of control. You can see how important a good September

1. The first step in building an RC helicopter.

Rc Helicopter

· Make sure all servos in the right direction when you move the right stick right, the pot is tilted to the right and then to the front and rear.
· Checkthe butterfly is correct and should not be on the radio the other way as TX.

2. Now that the servos move in the right direction, we need to center the servos.

Turn the plug ¸ radio receiver will ensure that the engine is taken when working on electric helicopters.
• Move the throttle stop halfway to get this all the servos to the middle position.
· Now we want to find the servo horn, the line-up is to keep up with 90 degrees centerMove up to make close or dead, you are putting in the screw, if you find one that works is found.

3. In addition, the swashplate is level you can buy a tool for your helicopter can cut or eyeball. • To reach the level swashplate suits arms that run from the servos to the swashplate.

4. We must also ensure that the leaching to block the plate.

• Washing Unit is one of the swash plate and the cage bar fly.
· Make sureBoth arms are level with each other, if not simply the arm flying off the cage goes up to. Slide Show Next we must ensure that the level of the fly arm bar
• Make sure that the fly bar arms are parallel to each other, if not simply stick the spear with which the swashplate.

5. Next is to ensure that the pitch can be controlled by the main blades.

• If half choke hold to ensure that the rotor blades at zero pitch
· Full-stick should be between 10Degrees to +12 degrees, depending on the style of flight
· Fund should stick -10 degrees to -12 degrees.

Now we have our head setup and ready to go. With all this together and we need a stable machine in level flight, this configuration gives the best chance to get off the ground. These are still some things to consider, as the curves of curved step configuration of the gas. radio setup in general, but that theme.

The setup of the tail can be difficult at times I foundthe best way to set the queue in order to get your rate of servants then make sure the bar is I set my cock with a certain degree of inclination of the tail begin to press your nose right on the main engine power to compensate and keep your nose in a just place. Over all the details I can not know the boy and gyroscope, which is used.

That all the basic configuration of the helicopter fun, safe, and keep it in the air Have a nice day!

How to make a RC helicopter

Golf Carts On